Desk chair covers – First, Measure the desk chair size. Trace the perimeter giving an inch from around the edge of the part of the backrest of the chair to the seat. Marks an inch (2.54 cm) around your path to the seams. Measures entire circumference of the seat of the chair. Add two inches (5 cm) to this figure. Cut the desk chair covers pattern. Wash, dry and iron the fabric. Fold it in half lengthwise, place your molds up and co locale pins. Cut two rear and one each seat and steering parts. Place the pieces back together on the right side and attach them with pins.
Sew around the curved side and the upper sections to within 1/2 inch (1.25 cm) for sewing. Leave the bottom without sewing. Remove the pins. Fold the cutouts of the part of the seat rolling desk chair covers to the backhand side and put in place with pins. Sew the hem sections armrest only with a margin for seam 1/4 inch (0.75 cm). Remove the pins. Make the long hem on the edge of the wheel turning 1/2 inch (1.25 cm) to the wrong side of the fabric. Put pins and sewing with a seam allowance 1/4 inch (0.75 cm). Connect the two short edges of the right side. Then sew them with a seam allowance of an inch to form a large circle.
Joins the remaining long edge of the circle to the other outer edges of the seat part with the right edges. Sew the pieces together with a margin for seam of an inch . Place the lower front edge of the rear cover flat against the rear edge of the seat part right joints. Place pins to hold them in place and sew leaving a seam allowance of 1/2 inch, leaving the rear of the free rear piece without sewing. Make hem the bottom edge of the rear side turning 1/2 inch and sewing it in place with a seam allowance of 1/4 inch. Turn all the cover on the right side and slide on your case. And your rolling desk chair covers was done.